-2l pop bottle
-socket a little smaller then the spout
-a bread bag
-a screen
-alot of electrical tape
1. cut the pop bottle at the bottom ridge.
2. place the pop bottle about 1/4 of the way inside the bag and
suck on the bag it shoud come to the spout perfect.
3. tape around the botom of the bottle once, then cut the excess of the bag off, then tape over and over again while slowly moving upwards.
*to make shur its air tight blow in and out alot of times but not 2 hard,
if it does leak take it more*
4. now take about 1 feet of tape and stick about an inch on the botom of the bag and fold it in half, then stick the remaining onto the oposite side of the bag.
5. OK, now take the socket and make shur it has a bit of room to move
and tape the top half of it enough so that it sits perfectly in the spout.
6. almost done, just push the screen all the way into the open end of the socket and there you go!
have fun geten baked and beter at brewing shoots im a king at it
now