homemade double bubbler?

[all_up_in_my_brain]

Someone i know has a double bubbler and that shit rocks. 2 chambers whole deal, i was wondering if there was a way to make one since im not of age to go to a head shop.

[flynn]

why don't you ask the person you know?

[artemis_likes_weed]

He bought it. And now that he graduated he moved away or else i would of asked him to buy me one. So any ideas?


This is my old name....im all_up

[...Farlan...]

umm this way may be crappy, but just make 2 homemade water bongs, so the sucking tube on the first one is connected 2 the intake on the secnd and u pretty much have a double bubbler

[cleric_of_the_bong]

I made a homemade double chamber out of pvc pipe with a small maglight bowl and it worked good a for like two bowls then the seals on the hoses began to leak. I used silicone sealant but it sucked, next time I'll have to use something better.

[newfie_crack]

I've made one before.
Materials: Two cylinderical plastic spice containers, or whatever containers, about 15cm high, a flat peice of wood, about 15cm square, three hoses, you can use hollowed out computer cords, just make sure they're the thinck ones. A socket, probably around 5mm in diameter, a peice of PVC piping, about 15cm long, electrical tape, and optionally, a stick of hot glue, the shit you have to melt.
Instructions: First, burn two holes in each container, one on each side, the same size as your hose, or a little bigger. On one container the holes should be about 4cm from the bottom, on the other, about 10cm. Then, drill or burn a hole in the lid of the container with the holes 10cm from the bottom, the same size as your hose. Tape the socket onto one end of a hose, (make sure your hose is as big or bigger than the bottom of your socket, or else you'll be smoking rubber). Stick the hose through the lid, (the hose should be long enough that it almost touches the bottom of the container) and screw the lid on when you're done the bong. Also, in the same container, burn a choke. Then, tape the PVC pipe to the top of the other container, (without the lid on of course). Then, stick one hose from one container to the otheron the right side, then do the same on the left side. NOTE: the connections MUST be completely airtight, or the bong will leak terribly. You can use silicone to seal the connections, or just wrap tape around the end of the hose, then stick it into the container. Then, wrap tape around the two containers, holding them together with the bottoms level. Lastly, attach the two containers to the peice of wood, preferrably with hot glue, as it holds very well. YOU'RE DONE! Now, fill the one container with enough water that it'll bubble well, without spilling out the choke, and fill the other container with enough water that the water level is 1-3cm above where the hoses enter it. Now pack that bowl, and double bubble your way to happy stonedness!