ne body have ne ideas

Fugdugly · Post by **Fugdugly** » Fri Jan 02, 2004 8:09 am

ive been makin pop bottle bongs and parachutes for me an my friends for years now and id like to step it up a notch in the quality department so a hawked a beaker from my science class i promptly began design and planned for how im going to make it a masterpiece when i realized have have no clue how to cut a hole in glass... a friend told me a blow torch and a straw would do the trick by heating it up and blowing out a hole but im a bit skeptical.. ne ideas as to how i shoudl attack this would be wonderful

bl8o m8o · Post by **bl8o m8o** » Mon Jan 05, 2004 12:25 am

ur friends right, but its too much of a mission to do, so just buy a proper bong.. itll prolly work better and its easier

weedguru tom · Post by **weedguru tom** » Mon Jan 05, 2004 1:20 am

just buy one man, if not use a glass cutter or glass drill bit

Cashy · Post by **Cashy** » Tue Jan 06, 2004 4:16 pm

failing that put a small coin inside and wing it around. dont expect a clean cut hole, but its somin to work with i guess (shield ur eyes when doing this foo)

Fugdugly · Post by **Fugdugly** » Wed Jan 07, 2004 9:58 pm

i have a few store bought bongs but i feel like i need a good glass homemade one to add to the collection

tankooo1 · Post by **tankooo1** » Thu Jan 08, 2004 6:52 am

well if you copped it from your science class its most likely 'pyrex' which is a special glass that withstands fire up to a fuckin high point.

www.weedguru.com

ne body have ne ideas

ne body have ne ideas

Who is online