how to make a lung( gravity bong)

Bongs, pipes, fuckbukets, lungs, vaporizers, grinders etc....

Moderator: Moderators

Post Reply
Bosco420
Why Hello There !
Posts: 2
Joined: Mon Apr 30, 2007 8:37 pm
Location: hampshire
Contact:

how to make a lung( gravity bong)

Post by Bosco420 »

it is the same basic design as a lung but a little different

your gonna need

1.) A bottle of any size
2.) A light
3.) A screwdriver
4.) A knife and pair of siccsors
5.) A small trash bucket (like you would find in a bathroom)
6.) Water
7.) Tinfoil
8.) Tape
9.) Weed

ok so first

1.) Take the cap of the bottle and hold it upside down so that u can see the inside where u screw it on the bottle. Take out the plastic peice inside of the cap

2.) Start to burn the bottom so that a hole burns through. If it begins to catch fire dont panic just blow it out

3.) Now that the plastic is burning/hot jab the screwdriver through it so u have a hole, make it a decent sized hole but twirling around the screwdriver and widening the hole as wide as you want the bowl to be

4.) Once the hole is in the top the hardest part is over, next your gonna need to take a peice of tinfoil and poke holes in it with a pin. the more holes u poke the easier it is to fill the body and the harder it will rip.



5.) Put the tinfoil in the hole to creat a bowl and secure the tinfoil with tape (duct tape will work best) and make sure that the cap is air-tight

6.) Now take the bottle and cut the bottom off near the base depending on how big u want your cavity and what size your trash can is

7.) Once this is all done you are almost ready to starting hittin it, but before you can you need to fill the trash can with water from a sink or bath tub

8.) THIS IS VERY IMPORTANT!!!! Take the cap off before you push the bottle down into the water or you will blow the bowl and lose your weed!

9.) Now once your cap is off and its filled with weed, push the cavity into the water until it almost reaches the top of the bottle. Now screw the cap on and light the weed while steadily lifting the bottle from the bottom of the bowl. This will creat a air vacuum, as you pull up the bottle, the smoke is dragged into the bottle.

10.) Once u have pulled the bottle up until the smoke is filled to the top unscrew the cap and suck in the smoke but make sure that you

a.) dont suck in the water
b.) dont lift the bottom of the bottle out of the water causing you to lose smoke from the cavity

[/img]
Post Reply

Who is online

Users browsing this forum: No registered users