Easy ass pipe....Just poke a hole in the popcan....Crush the popcan down so that the two sides are still up....and there.....Then if u want the choke u just put it down by the buttem?
Front part (With hole)
________/ Crush
|/
| <<Place hole somewhere over there
|
|\
|_______\ <<Crush
^ Now if u want the choke put it down there
Easy nuff? Right?
I dont know if someones said it already but who cares i am bored....
ok....Easyiest pipe i could think of...aint the quickest but.,..
Get a popcan and Rip off a Rectangluer shape out of it/....
Get a Pen....Empty it out....
figure out a way to put a hole in the pen....not big tho
Then Take ure rectangleer piece of popcan....and Stick a hole with a pen...
Then Put the Popcan piece over the whole....
Then take some glue and put it on...to put together popcan and pen thingy right?
Then kinda bend the Popcan piece....
\ / << Twisted up Popcan piece?
======_=== << Pipe? pen thingy?
^ hole?
I dont think u should keep it burnin real long if u got a plastic piece of pen....Because itd melt....And proply reck your dope...
take a bottle of anything big liek 1.5 L or 2 L bottles...
take a lighter and keep the flame close to the bottle about 1/3rd way up just to burn a small hole not too big... then take a hollow pen tube.. or u can cuz out a piece of rectangular aluminum from a can and roll it and tape it into a cone... anyways put this into the bottle but make its angle small.. like make it facing up.. try taping it close to the bottle to make it stand... then put something u can fit the weed into or u can fit it into the cone of aluminum which u should put into the end of the pen tube(smaler one) if u are using the pen tube.. anyways put the weed.. fill it up a bit with water so the pipe is submerged and suck out the top while u light the weed.. make a shottie hole if u want about a bit more than 1/2 way up the bottle