materials:
pop bottle (250 ml or so)
shaft(2-3 inches long threaded ont he outside)
lighter
weed
Procedure:
1. take you lighter and burn a hole about 1/3 of the way up the bottle that is slightly smaller than you shaft.
2. before the plastic drys take your shaft and thread it through the hole on as much of an angle towards the mouthpiece as possible... thread it untill about 1/2 an inch is showing out the top.
3. check for air tightness.. if its not airtight take some duct tape and unthread the shaft baout an inch, wrap the duct tape around the shaft and thread it back in...
4. Voilia theres your popper bottle
now come the tricky part, packing the popper:
1. take a cigarette and rip a little it off the end.... just enouigh to fit snugly int he top of the tube. this is you plug
2. now take some weed ( about 2 times as much as tobacco) and put it ontop of the plug(tobacco) forsing it down father in the shaft.
3. now take your lighter and brew up the mix untill it is ash and starts to fall through. then pull as hard as you can, forcing all the smoke into you lungs... it give you a mad headrush followed by a full body high....
now most people get turned off by the fact of there biend 1/15 th of a smoke in the popper... but you learn to get used to it... i can get 3 times a high off 3 times less weed as jsut smoking normal bongs... and there is no excess smoke wiht poppers cause it goes right fromn the bottle to your lungs.
