I HAVE A BONG PROBLEM

NoSticksorStems · Post by **NoSticksorStems** » Thu Jun 10, 2004 4:54 pm

HI NEED SOM HELP WID THIS BONG IT WORKS AND EVERY TING
BUT THE SMOKE WONT HOLD IN THE CHAMBER SO IT GIVS A
CRAP TOKE HELP ME PLEASE!!!

riff · Post by **riff** » Thu Jun 10, 2004 5:06 pm

i'm not sure what's going wrong but it would be easier to change the design so the pipe goes in a hole a couple of inches from the bottom so you can submerge it in water then put the gauze on the other end othe pipe (use foil if it doesn't fit). maybe that'll take a long time, i'm not used to bongs like that, sorry man. you got the munchies sorted though, there's no beating a nice blackjack

hope it works out bud.

Midnight Toker · Post by **Midnight Toker** » Thu Jun 10, 2004 8:46 pm

Chances are its not airtight. Cover up the rush hole and the gauze, then blow into the bong. If you hear air escaping, run your hand over the bong until you determine where its coming from, then cover up the gap with blue tac/tape.

Weedguru Sensei · Post by **Weedguru Sensei** » Thu Jun 10, 2004 9:57 pm

What MT said, it's obviously not airtight if it's not giving good tokes.

weedguru tom · Post by **weedguru tom** » Thu Jun 10, 2004 10:15 pm

wtf, you dont make a water bong like that, make one liek this, sry about the drawin tok me about a min to draw it.

onei made earlier

clashcityrocker · Post by **clashcityrocker** » Fri Jun 11, 2004 10:00 am

EDITED: Oops. I misinterpreted your picture, I thought the tube sticking out of the side was the stem, and the mouthpiece was the bottle lid part....

Anyway, your bowl totally sucks. Is it suspended in the air by like a paper clip or something?! That will not work at all, in fact its a total waste of weed.

The mouthpeice doesn't look like its stuck in the bottle right, the hole looks like it too is not airtight.

Long story short, throw it away and make a new one

Post by **WeedGuru_Flow** » Fri Jun 11, 2004 12:27 pm

is silicone a non toxic thing?

weedguru tom · Post by **weedguru tom** » Fri Jun 11, 2004 4:12 pm

no, i wouldnt use silicone

use tape and after you have taped it up, get a lighter and hover it over the tape for a few secs and it makes the tape go floppy n soft, then with your finger (BUT PLEASE DONT BURN YOUR SELF) rub it into the gaps mould it around the downpipe etc.. then it will cool n go back to normal.

Post by **WeedGuru_Flow** » Sat Jun 12, 2004 4:44 pm

the fumes from the melting tape are supertoxic, i think silicone is safer then

==> I plan on using it on my glasswodkabottlewaterpipe, sjek the bongs forum

NoSticksorStems · Post by **NoSticksorStems** » Sun Jun 13, 2004 5:05 pm

alright alright i got it sorted i sealed the mouth hose with a silcon sealent gun the stuff you seal your baths and showers with seems to be working fine thanks every one

www.weedguru.com

I HAVE A BONG PROBLEM

I HAVE A BONG PROBLEM

Who is online