Page 1 of 1

problem. help plz :(

Posted: Mon Jan 19, 2004 6:30 am
by stnoed
hi. i made this bong, and now that im sober and lookin at it i think the plastic pipe might be too close to the bowl. im a shitty, shitty drawer but i hope you understand. here goes nothin:

Image

Posted: Mon Jan 19, 2004 6:32 am
by cryptic
NONO dont do it, ive smoked plastic pen before and it is not an enjoyable experience

Posted: Mon Jan 19, 2004 6:36 am
by stnoed
rofl i know that. im sayin do u think i should add something metal after the pen part. i keep testing it with tabacco and its not melting or even getting that hot..

Posted: Mon Jan 19, 2004 11:26 am
by herbal stu
awww pwetty pictwure!

Posted: Mon Jan 19, 2004 3:54 pm
by seedy fella
stnoed wrote:i keep testing it with tabacco and its not melting or even getting that hot..
then leave it cos it should work then... o btw how the hell do u put that mesh stuff in to stop it all fallin cos i just dont understand how that would work.. PLEASE EXPLAIN ( i hate pauline hanson racist bitch) :lol:

Posted: Tue Jan 20, 2004 1:40 pm
by GodHand Kronix
Think this should go in the pipes or bongs section...

Posted: Tue Jan 20, 2004 11:56 pm
by the mac
You THINK?!
:D

if its not burning when you smoke tobacco in it then use it..

Posted: Wed Jan 21, 2004 12:01 am
by weedguru_asmodeus
moved...

Is there any way you can increase the distance between the mesh and the pen?, maybe by increasing the width of the highlighter using some other material to wrap around it? or putting a couple of metal washers underneath the mesh to raise it out of the bowl a little? try this then just burn baccy to test if the pen gets hot - but you really dont want to inhale plastic, that shit wont be good for you.

Posted: Sun Feb 01, 2004 8:00 pm
by slippy
Ì think you should become an artist :D

Posted: Wed Feb 11, 2004 3:41 am
by stnoed
um the mesh just stick it in and cut it it to fit tightly.. and thats it.