pipe meaking
Posted: Sat Dec 27, 2003 3:08 am
im going to make a pipe out of wood and i want to know how to curve the stem and how to drill or hollow it out since drill bits dont curve how would i go about doing this
Page 1 of 1
Posted: Sat Dec 27, 2003 7:24 am
I can't remember shop class, so I can't really help you. I just wanted to let you know I moved your other topic about pipes to the "pipes" forum. So you could find it if you come back.
Posted: Sat Dec 27, 2003 10:10 am
my friend had a wicked wood pipe. he made it by hollowing out a stick with a screwdriver.
Re: pipe meaking
Posted: Sat Dec 27, 2003 10:26 am
Take a bit of wood and drill a hole straight through the centre, but leave about 1.5cm at the end without a hole. Then drill another hole through the top until it joins up to the other hole. The get a chisel and curve the hole on the top out until it is the right size and shape for a bowl. Then saw, file or chisel (depending on personal preference) the pipe to the desired shape. Then sand down the whole surface till it's nice and smooth. That's probably the easiest way to get a nice wooden pipe if you do it right.
Posted: Sat Dec 27, 2003 12:50 pm
this should be in the pipe section >;/
Posted: Fri Jan 02, 2004 3:21 am
my friend has a kick ass wooden pipe...but i never asked how he made it...i think it was with a small screwdriver
Posted: Sun Feb 01, 2004 8:51 pm
u been smokin 2 much this is the pipe sectiontom wrote:this should be in the pipe section >;/