www.weedguru.com

All you need is a water bottle, scissors, and some alluminum foil.

Cut a hole about 1-3 cms in the middle of the upper part of a waterbottle where the logo is. You will hit out of this, so make it big enough to get a good hit out of, and small enough so your mouth can cover it easily.

Next make a bowl on the top of the bottle with the alluminum foil, and make it as deep as how much weed you want to put in. Poke holes in the foil with a pin or something sharp and pointy like that. Evenly distribute the small holes all around the foil bowl.

Load it up, light it up, pull at the mouthhole, and get really really fucking high. Smoke fills the bottle too, so you can get quite a few hits.

Very fast and easy alternative to rolling.

cool!
i've never done bottle tokes before!

Sensei wrote:cool!
i've never done bottle tokes before!

Seriously?

A bottle pipe was all I had until a few weeks ago.

blazed wrote:Sarcasm.

Maybe, maybe not... its 9.5mm we are talking about here.

Maybe he has never had to be ghetto and use crap bongs.

haha well that could be, but i sense sarcasm

I'm definitally not throwing out the possibility either way

I basically did that, except where I cut the hole I put a pipe in and hit out of the top.

yah, try putting the hole as far down as possible too, to make the hole bottle creamy