Page 1 of 2
Making holes in a glass bottle
Posted: Mon Nov 10, 2003 11:18 pm
by Stoned Lil Freak
How wud the simplest method of making a hole or two in a glass bottle? Normal Drill? Heat or something?!?! I really needta know this..
Posted: Mon Nov 10, 2003 11:23 pm
by Weedguru Higher
The simplest way would be too not do it at all

Posted: Mon Nov 10, 2003 11:24 pm
by Stoned Lil Freak
Your being any help Higher

...C'mon there's gotta be someone who's put holes in glass bottles before...TELL ME HOW YOU DID IT!!
Posted: Mon Nov 10, 2003 11:29 pm
by Midnight_Toker69
I know how u can get one in the very bottom of one...put a dime or penny or something in a bottle, so its in the bottom, then hold a lighter underneath of it and it'll get right hot n make a hole in it. but if u want one for a bong...i'd say get like a diamond bit for a drill or something
Posted: Mon Nov 10, 2003 11:32 pm
by Stoned Lil Freak
That won't work.....Wut bout that penny/dime thing but holding the bottle sideways?! And how long wud u hafta hold the lighter there!?
Posted: Mon Nov 10, 2003 11:35 pm
by Midnight_Toker69
For a few mins...cuz u basically gotta get it reeeeally hott before it goes threw
Posted: Tue Nov 11, 2003 12:03 am
by Tarential
Drill works fine.
Posted: Tue Nov 11, 2003 12:06 am
by Stoned Lil Freak
completely normal drill bits will go through glass?
Posted: Tue Nov 11, 2003 12:06 am
by Tarential
That has been my experience thus far.
Posted: Tue Nov 11, 2003 12:07 am
by Stoned Lil Freak
Hmm..Guess I'll hafta try after my rents go to bed...If it works I'm taking a pic of it and posting it on here for u guys,...and also if I can find a small enough drill bit to make something else into a pipe,,,I'll show u

Posted: Tue Nov 11, 2003 6:01 am
by th3rdeye
what I've seen, is if you fill the glass with water, than freeze the water...THAN drill, it should come perfect
Posted: Tue Nov 11, 2003 6:28 am
by GirlSetsFire
glass breaks when you freeze it with water in it...
Posted: Tue Nov 11, 2003 6:29 am
by th3rdeye
not too much water...so It expands up and not out
Posted: Tue Nov 11, 2003 7:51 am
by smoke two joints
where the hell were you guys when i wanted to know how to do it... psha
anyway the best advice i got so far was.. if youre going to cut a hole in it with a normal drill bit, fill it with jello.. or peanut butter.. or some kinda gelatin.. vasoline.. something so that if it breaks on you, it doesnt go all over the place and bust on your hands.. a diamond drill bit will work, i just ordered mine and they're in the mail.. i'll let you know how mine works out.. also check out my post, its on here somewhere, labeled "creation"
Posted: Tue Nov 11, 2003 8:59 am
by weedguru tom
yup glass drilling bits