Page 1 of 1

Cone Problem :(

Posted: Wed Jul 23, 2003 12:26 pm
by Wofen
I have a problem, and it is that I have just made a large bong for 4 pplz, and the place where the cone is ment to go is about 42mm large.

Now, heres my problem, One) Should I leave the hole that size and make a large cone, and if I do that, it would need lots of weed, but would own. And where would a I get/make a cone that size from

Two) Should I make it smaller, and if so, how much smaller(its a 5 gallon bong, made for 4 pplz)???

Thanks

Posted: Wed Jul 23, 2003 1:37 pm
by Ellington
I make allmost all my bowls from wood nowadays..you can get it every size you want and engrave it and stuff :)

Posted: Sat Aug 02, 2003 6:59 am
by Wofen
Dont worry, the answer came from one of my quick thinking mates, who cuts a can open, and we made it from that. it was cool.

Posted: Sat Aug 02, 2003 2:52 pm
by herbal stu
When u say 'can' pls say u aint on about an aluminium can!! People with Alzheimers (sp?) have been found to have more than average traces of aluminium in the brain and rather isk such an awful disease I wouldnt use it but if you want to end up in that state carry on :? I'd recommend makin it smaller it wouldnt take people as long to take their bowl and so people dont have to wait ages :)

L8az dude