Page 1 of 1

Kief Pressing Explained

Posted: Sun Mar 28, 2010 2:27 pm
by Weedguru Higher
Kief Pressing Explained

The hash making techniques leave you with a product that, once dried, resembles sand. This "sand" is actually a collection of trichome heads and stalks. In Holland, these heads are referred to as "pollen" or "polm," which can create confusion as the trichomes are clearly not a "pollen" as defined by the english use of the word. Because it is a powder and a potent cannabis extract, this raw product is also sometimes jokingly referred to as "hippy crack."

Image Image

The final step to making hash is to turn this powder into a solid mass. This can be as simple as rubbing small quantities between your hands to produce a ball of resin, as our ancestors did thousands of years ago. (Unlike our ancient ancestors, you should wash your hands first!)

Image Image

Another way is to press this powder into a bar or cake. The powder should be completely dry before pressing. If it stored damp it can become moldy, ruining your precious product. So be sure it is totally dry! If you put it into the freezer for a while the water inside will coagulate on the surface as ice and can then be blotted off.

Image Image

The pressing technique used determines far more than just the overall aesthetic of the final product. The way the hash will burn, store, taste and smell are all altered and ideally improved by pressing. Before anything gets pressed, the powder/kief/gland heads – whatever you call it – has to be put into cellophane wrapping. Now, cellophane is not the same as a Ziploc baggie or saran-wrap (cling-wrap). Cellophane is the thin “crispy” cheap plastic that covers most store-bought items, the non-sticky clear wrap packaging you find on unopened cigarette cartons, for example. Ziploc baggies, however, are made with plastic polymers that actually bond with resin heads and cannot be separated. So don’t use a plastic baggie for pot if you can avoid it – especially when you have some really sticky-icky ganja!

Image Image

To properly press resin, you must heat it, but not melt it. You should be able to hold the heat source; otherwise, it’s too hot. A hair dryer can provide just enough warm air to make the sticky resin more workable. One of the easiest ways to do a warm press is to fill a sealable glass bottle with hot tap water, and use it like a rolling pin to press small packets of resin. If the hash quality is high, a quick roll will stick everything together. Breaking or folding and repressing hash several times helps create consistent product, which also tends to be nice and gummy. Another old trick is the shoe press: a small piece of kief is wrapped in cellophane, placed inside a shoe, and walked on. After a while, the pressure and warmth create a solid piece of hash. It makes your posture a little gimpy, but it works!

Image
Shoe Hash

A remarkably good press can be achieved with a lot of stuff lying around. Some options that come to mind are putting it in a vice, placing it between two boards and driving over it with a car, or just whacking the crap out of it (inside cellophane) with a rubber mallet. For small amounts like half an ounce or less, the Piecemaker from GreenHarvest.ca is a damn fine tool to press up to 20 grams of resin heads. It’s compact but generates all the torque necessary to properly press a very nice hunk of funk, and comes with a few pressing pieces to make perfect five-gram hash coins. About 30 seconds from a hair dryer warms it quite evenly, and the heat really helps the resin to bond into a solid piece. There are numerous other contraptions on the market, so do some research and you’ll find exactly what you’re looking for.

Image Image
Commercial Hash Presses