Page 1 of 1
Making holes in glass
Posted: Mon Jul 30, 2007 6:01 am
by mingusfan
So i got a bunch of awesome glass bottles and such the need bong transformations but I have no idea how to make holes in said bottles without breaking them. Any ideas?
Posted: Mon Jul 30, 2007 6:04 am
by swanee89
diamond tip glass cutting bits for dremels. just go to your local sears or hardware store
Posted: Mon Jul 30, 2007 2:38 pm
by SpRi7e
Just remember the drill bits are fairly expensive, enough to buy a pretty good acrylic bong.
Posted: Mon Jul 30, 2007 6:08 pm
by Liles
You could always file it away, but it'd take ages and might crack if given too much pressure.
Diamond drill bits are the way to go, ask your friends if they or know anyone that has one.
Posted: Wed Aug 01, 2007 2:38 am
by captainMorton
those damaged screw remover bits work awsome!
Posted: Thu Aug 02, 2007 6:50 pm
by Movement of Jah People
I'm pretty sure that there are glass drills or something similar that drill into the thing without shattering it.
Posted: Thu Aug 02, 2007 9:09 pm
by blackxs
Yeah usually the remover tools for stripped screws are very strong and very very thin, so that may be a possibility. Ask at a hardware store for tools to remove a stripped screw.
Posted: Fri Aug 03, 2007 8:36 am
by Sm0kyMcPot
is there anyway to like carver a hole with a razor blade and then carefully punch it up with like a nail set or something, or is this to risky?
Posted: Fri Aug 03, 2007 12:54 pm
by weedheart
all i did for my homeade bong was take a pocket knife and put it on the glass and tap the knife with soemthing slowly,it took about 20 mins but made gooooood holes in the glass(i used a screwdriver cuz i culdent find my hammer)