Page 1 of 1
new pipe with resin
Posted: Sun Jan 08, 2006 2:52 am
by sp0rkeh
ok i just got a new pipe from a bud of mine that he was getting ride of and it still has all the resin.... and i was wondering do i just scrap the resin out and roll it in a ball if i can or just put all the peices of scrapings in the pipe and light it up?
and will this taste like shit or will it taste just like bud?
Posted: Sun Jan 08, 2006 2:58 am
by Dr. Greenthumb
it doesnt taste like bud. as for tasting bad that depends on opinion.
the best way to scrape it is with a bent paperclip and try to wear gloves as it will get sticky. once you collect it you roll it up into a ball or anything that will fit in your bowl and smoke it. make sure you hold the flame to it for a while in order to heat it. it is best when you mix bits of weed into the resin but either way the resin will get you high
Posted: Tue Jan 10, 2006 10:38 am
by Weedguru_RyaNayR
I use allen wrenches.
Anyway, a good way to get it out easier is to let it soak in water for about 5 minutes, and when you collect it, it just comes right off. This only works with glass I think. And THC isn't water soluble. The water just loosens resin. You can smoke it wet but it crackles alot.
Posted: Wed Jan 11, 2006 2:12 am
by ++ZER0++
my friend collects resin so that in case he doesnt have weed, he can smoke his resin
Posted: Wed Jan 11, 2006 3:31 am
by Dr. Greenthumb
RyaNayR wrote:I use allen wrenches.
Anyway, a good way to get it out easier is to let it soak in water for about 5 minutes, and when you collect it, it just comes right off. This only works with glass I think. And THC isn't water soluble. The water just loosens resin. You can smoke it wet but it crackles alot.
try rolling it up in a ball after taking it out, pad it down and stick it in the freezer for ten minutes that way you got a good solid