How to make an air tight bong
Posted: Fri Dec 02, 2005 6:02 pm
wot u need:
small coke bottle
a plastic tube abouts the same width as the coke bottle nek
half a bike inner tube for a maountain bike
knife
masking tape
blue-tac
10 cm of hose pipe
a socket
and a gauze
cut a hole abouts 1/3 of the way up the bottle and feed the hose pipe through so its near the bottom of the bottle. cut hose to how big you want it out of the bottle.
put lots of blue tac round the top of the hose on the bottle then add the tube to the top of the bottle and use the masking tape to secure it tightly.
then get your inner-tube and strech it over the bottle and cut a hole and feed the downpipe through it the on the other side cut your shotgun hole.
then this part is tricky get your socket and put it in the hose pipe and add your gauze to it
then add your water
if you use flavoured juices too add a bit of flavour rememba not to use fizzy drinks andto change evry so often
then add your mix and get sToNeD.....
small coke bottle
a plastic tube abouts the same width as the coke bottle nek
half a bike inner tube for a maountain bike
knife
masking tape
blue-tac
10 cm of hose pipe
a socket
and a gauze
cut a hole abouts 1/3 of the way up the bottle and feed the hose pipe through so its near the bottom of the bottle. cut hose to how big you want it out of the bottle.
put lots of blue tac round the top of the hose on the bottle then add the tube to the top of the bottle and use the masking tape to secure it tightly.
then get your inner-tube and strech it over the bottle and cut a hole and feed the downpipe through it the on the other side cut your shotgun hole.
then this part is tricky get your socket and put it in the hose pipe and add your gauze to it
then add your water
if you use flavoured juices too add a bit of flavour rememba not to use fizzy drinks andto change evry so often
then add your mix and get sToNeD.....
