how to make a bubbler

[bublybong]

Alright heres what u need:
pen
plastic 20oz
socket peice that can fite the pen
knife
weed
lighter

1.take apart pen so that there is just a tube left
2.take cap off 20oz heat up knife then slowly make a hole big enough to fite the pen is right above where the the edge is
3.put pen inhole going into the botom
4.put rachet peice on end of pen
5.fill botle with enogh water to put the end of the pen in it but not high enogh to get to the hole
6.fill peice with weed
7. light it up and suck out of where u normaly drink
reply how yours went plz

[make-bongs]

man, that works asome,but i found if u use that tubing from fishtanks for the air pumps it works dam good with it taped to the bottle