www.weedguru.com

I always like making waterfall bongs when im chillin with lots of people. will get you high really fast and fun as hell to do.
Heres what you do:
~get a 2liter bottle, a lighter, tin foil, knife, and a good bit of weed.
~cut a small hole in the very bottom of the 2liter, about the size around of a pen
~melt a hole in the cap of the 2liter and make a bowl with the tin foil
~fill the 2liter with water to the very top (make sure to cover the whole)
~now the fun part, screw on the packed bowl and hold a flame over it, then take your finger off the hole and let the water drain out. then just watch as the 2liter fills itself with smoke.
~when all the water is drained, unscrew the bowl and take a hit off that shit and pass.
It holds all the smoke in good and is a great party bong. try it

good idea

Yep i make these for my sisters gravity bong sometimes. I like it better than the gravity bong cause you wont get that nasty water in your mouth, but downside is you have to lift it out of the bucket and when your really high its easy to spray the bongwater all over your carpet

my waterfall system consists of: 600 ml pop bottle with a socket melted and pushed through the plastic lid to make an airtight bowl. I use a utility knife to slice a small hole on one of the tits at the bottom of the bottle. I fill a milk jug up with water and push the bottle down into the water. The bowl is just the right size so that when i light it and bring it up the bowl is pooched when there's just a little bit of water still in the bottle. Then i raise it out of the water and hit it with the water still in the bottom of the bottle, which gives you a filtered bong toke.

I also have a 2-litre system but i like the 600 ml waterfall best because it's very conservative and if you know how to pack and brew waterfalls well, you can get impressive hits with small amounts of bud.

Bongsnbongos420 wrote:my waterfall system consists of: 600 ml pop bottle with a socket melted and pushed through the plastic lid to make an airtight bowl. I use a utility knife to slice a small hole on one of the tits at the bottom of the bottle. I fill a milk jug up with water and push the bottle down into the water. The bowl is just the right size so that when i light it and bring it up the bowl is pooched when there's just a little bit of water still in the bottle. Then i raise it out of the water and hit it with the water still in the bottom of the bottle, which gives you a filtered bong toke.

I also have a 2-litre system but i like the 600 ml waterfall best because it's very conservative and if you know how to pack and brew waterfalls well, you can get impressive hits with small amounts of bud.

Well said Nate. The socket we use is 5 mm in diameter, and is smaller at the bottom than the top. It's better to use one like that, because after long sessions, the bowl gets really hot, and if you're using the straight sided kind of socket, the bowl often falls right through the cap, and into the water. I've had that happen to me a bunch of times with my chute.

a good way to make waterfall bongs is using a glass sobe energy drink bottle. They have a little indented part o at the bottom. You then use a hammer and hole punch thing (fuck cant think of name but is kinda like a nail you use before drilling on big pices of metal) anyway you hit in the indented pice and it makes a perfect little hole. Then you make a bowl and what ever you usually make on your waterfall bongs.

love doin that

Hmm sounds good. I will try that to night. Thank you.